Hand Grips

Guide for installing, removing or adjusting the Hand Grips on all CycleBoard models.

Required Equipment

  • 3 mm Allen Wrench
  • 5 mm Allen Wrench

Recommended Equipment

  • Rubber Mallet (Hammer)


  • Loosen the Grips - Use a 3 mm Allen Wrench to loosen the screw on the collar of the handgrip and a 5 mm Allen to loosen the screw at the end of the handgrip (2-3 turns).



  • Remove the Hand Grip - Twist the handgrip with one hand as you pull it off. If it is too hard to remove then loosen the end screw 1 revolution at a time until the handgrip can be pulled off.



  • Install the Hand Grip - When installing the handgrip use a rubber mallet to tap it onto the hand bar to make it easier to install then tighten the 5 mm screw on the handgrip.

Have more questions? Contact support@cycleboard.com