Comprehensive Guide of all connectors used on CycleBoard models.
Battery Connectors
XT- 90 - Pull apart firmly at the connector to disconnect.
Deans - Pull apart firmly at the connector to disconnect.
Motor Connectors
Connector Type 1 - Twist the silver ring loose (counterclockwise) before pulling apart. Align pattern on the connector to push together and twist the silver ring clockwise to secure.
Connector Type 2 - Pull apart firmly at the connector to disconnect. Align the arrows on each side of the connector before pushing back together.
Connector Type 3 - Pull apart firmly at the connector to disconnect. Align the arrows on each side of the connector before pushing back together.
Connector Type 4 - Score the shrink tube carefully with a knife and peel away by hand to remove from the 3 motor connectors and the sensor connector. Press the clip on the sensor connector before pulling apart. Ensure the 3 motor wires are covered with the green covers when plugged back together (new motors or controllers will come with new green covers).
Controller/Throttle Connectors
Connector Type 1 - Pull apart firmly at the connector to disconnect. Align the arrows on each side of the connector before pushing back together.
Connector Type 2 - Score the shrink tube carefully with a knife and peel away by hand to remove before pulling the connector apart. The 5 silver tabs should only be visible on one connector when pushing together.
Connector Type 3 - Score the shrink tube carefully with a knife and peel away by hand to remove and then press down on the latch to unlock before pulling apart.
